Sample technician2006 test paper

Practice FCC technician2006 Practice Test

Click the buttons corresponding to your desired answers and to have your paper graded press the 'Submit Paper' button which is found at the end of the examination page.
As in the real examination, do not forget to check your paper before you submit it for marking, there is no time limit within which the paper has to be completed, so do not feel compeled to rush through. Any illustrations required for a particular question will be shown below that question. If you have a text based browser, you should consult a copy of these illustrations, which are available from the ARRL.
 
Q 1:  What is a commonly accepted value for the lowest voltage that can cause a dangerous electric shock?
 (T0A01)
 
A. 12 volts.
B. 30 volts.
C. 120 volts.
D. 300 volts.
 
 
Q 2:  What is an important consideration when putting up an antenna?
 (T0B04)
 
A. Carefully tune it for a low SWR.
B. Make sure people cannot accidentally come into contact with it.
C. Make sure you discard all packing material in a safe place.
D. Make sure birds can see it so they don't fly into it .
 
 
Q 3:  How can you determine that your station complies with FCC RF exposure regulations?
 (T0C06)
 
A. By calculation based on FCC OET Bulletin 65.
B. By calculation based on computer modeling.
C. By measurement of field strength using calibrated equipment.
D. All of these choices are correct.
 
 
Q 4:  What classes of US amateur radio licenses may currently be earned by examination?
 (T1A03)
 
A. Novice, Technician, General, Advanced.
B. Technician, General, Advanced.
C. Technician, General, Extra.
D. Technician, Tech Plus, General.
 
 
Q 5:  What numbers are used in US amateur call signs?
 (T1B10)
 
A. Any two-digit number, 10 through 99.
B. Any two-digit number, 22 through 45.
C. A single digit, 1 though 9.
D. A single digit, 0 through 9.
 
 
Q 6:  What amateur band are you using if you are operating on 223.50 MHz?
 (T1C08)
 
A. 15 meter band.
B. 10 meter band.
C. 2 meter band.
D. 1.25 meter band.
 
 
Q 7:  Who can become an amateur licensee in the US?
 (T1D02)
 
A. Anyone except a representative of a foreign government.
B. Only a citizen of the United States.
C. Anyone except an employee of the US government.
D. Anyone.
 
 
Q 8:  When is an amateur station authorized to transmit music?
 (T2A02)
 
A. Amateurs may not transmit music, except as incidental to an authorized rebroadcast of space shuttle communications.
B. Only when the music produces no spurious emissions.
C. Only to interfere with an illegal transmission.
D. Only when the music is above 1280 MHz.
 
 
Q 9:  How often must you identify using your assigned call sign when operating while using a special event call sign?
 (T2B08)
 
A. Every 10 minutes.
B. Once when the event begins and once when it concludes.
C. Never.
D. Once per hour.
 
 
Q 10:  What is the definition of a control operator of an amateur station?
 (T2C12)
 
A. Anyone who operates the controls of the station.
B. Anyone who is responsible for the station's equipment.
C. An operator designated by the licensee to be responsible for the station's transmissions to assure compliance with FCC rules.
D. The operator with the highest class of license who is in control of the station.
 
 
Q 11:  How many persons are required to be members of a club for a club station license to be issued by the FCC?
 (T2D06)
 
A. At least 5.
B. At least 4.
C. A trustee and 2 officers.
D. At least 2 .
 
 
Q 12:  What is the meaning of the procedural signal "CQ"?
 (T3A08)
 
A. Call on the quarter hour.
B. New antenna is being tested (no station should answer).
C. Only the called station should transmit.
D. Calling any station.
 
 
Q 13:  Which of these statements is true about legal power levels on the amateur bands?
 (T3B07)
 
A. Always use the maximum power allowed to ensure that you complete the contact.
B. An amateur may use no more than 200 Watts PEP to make an amateur contact.
C. An amateur may use up to 1500 Watts PEP on any amateur frequency.
D. An amateur must use the minimum transmitter power necessary to carry out the desired communication.
 
 
Q 14:  What should you do if you hear a newly licensed operator that is having trouble with their station?
 (T3C07)
 
A. Tell them to get off the air until they learn how operate properly.
B. Report them to the FCC.
C. Contact them and offer to help with the problem.
D. Move to another frequency.
 
 
Q 15:  What rules apply to your station when using amateur radio at the request of public service officials or at the scene of an emergency?
 (T3D09)
 
A. RACES.
B. ARES .
C. FCC.
D. FEMA.
 
 
Q 16:  What is the name for the flow of electrons in an electric circuit?
 (T4A03)
 
A. Voltage .
B. Resistance .
C. Capacitance .
D. Current .
 
 
Q 17:  Electromagnetic waves that oscillate more than 20,000 times per second as they travel through space are generally referred to as what?
 (T4B04)
 
A. Gravity waves.
B. Sound waves.
C. Radio waves.
D. Gamma radiation.
 
 
Q 18:  What is used to convert radio signals into sounds we can hear?
 (T4C01)
 
A. Transmitter.
B. Receiver.
C. Microphone.
D. Antenna.
 
 
Q 19:  What is the voltage across the resistor if a current of 1 ampere flows through a 10 ohm resistor?
 (T4D08)
 
A. 10 volts.
B. 1 volt.
C. 11 volts.
D. 9 volts.
 
 
Q 20:  What is the formula used to calculate electrical power in a DC circuit?
 (T4E02)
 
A. Power (P) equals voltage (E) multiplied by current (I).
B. Power (P) equals voltage (E) divided by current (I).
C. Power (P) equals voltage (E) minus current (I).
D. Power (P) equals voltage (E) plus current (I).
 
 
Q 21:  Which piece of station equipment converts electrical signals to sound waves?
 (T5A02)
 
A. Frequency coordinator.
B. Frequency discriminator.
C. Speaker.
D. Microphone.
 
 
Q 22:  What is the purpose of the "shift" control found on many VHF/UHF transceivers?
 (T5B08)
 
A. Adjust transmitter power level.
B. Change bands.
C. Adjust the offset between transmit and receive frequency.
D. Change modes.
 
 
Q 23:  What is the main reason repeaters should be approved by the local frequency coordinator before being installed?
 (T5C12)
 
A. Coordination minimizes interference between repeaters and makes the most efficient use of available frequencies.
B. Coordination is required by the FCC.
C. Repeater manufacturers have exclusive territories and you could be fined for using the wrong equipment.
D. Only coordinated systems will be approved by the officers of the local radio club .
 
 
Q 24:  What is the most likely cause of telephone interference from a nearby transmitter?
 (T5D03)
 
A. Harmonics from the transmitter.
B. The transmitter's signals are causing the telephone to act like a radio receiver.
C. Poor station grounding.
D. Improper transmitter adjustment.
 
 
Q 25:  Which sideband is normally used for VHF and UHF SSB communications?
 (T6A07)
 
A. Upper sideband.
B. Lower sideband.
C. Suppressed sideband .
D. Inverted sideband.
 
 
Q 26:  What are you listening to if you hear a brief tone and then a station from Russia calling CQ on a 2-meter repeater?
 (T6B08)
 
A. An ionospheric band opening on VHF.
B. A prohibited transmission.
C. An Internet linked DX station.
D. None of these answers are correct.
 
 
Q 27:  What sending speed is recommended when using Morse code?
 (T6C08)
 
A. Only speeds below five WPM.
B. The highest speed your keyer will operate.
C. Any speed at which you can reliably receive.
D. The highest speed at which you can control the keyer.
 
 
Q 28:  What is the maximum power allowed when transmitting telecommand signals to radio controlled models?
 (T7A11)
 
A. 500 milliwatts.
B. 1 watt .
C. 25 watts.
D. 1500 watts.
 
 
Q 29:  What is Doppler shift?
 (T7B07)
 
A. A change in the satellite orbit .
B. A mode where the satellite receives signals on one band and transmits on another .
C. A change in signal frequency caused by motion through space .
D. A special digital communications mode for some satellites .
 
 
Q 30:  What should you do if you hear someone reporting an emergency?
 (T8A08)
 
A. Report the station to the FCC immediately .
B. Assume the emergency is real and act accordingly.
C. Ask the other station to move to a different frequency .
D. Tell the station to call the police on the telephone .
 
 
Q 31:  Why should casual conversation between stations during a public service event be avoided?
 (T8B09)
 
A. Such chatter is often interesting to bystanders.
B. Other listeners might overhear personal information.
C. Idle chatter may interfere with important traffic .
D. You might have to change batteries more often.
 
 
Q 32:  What should you do to minimize disruptions to an emergency traffic net once you have checked in?
 (T8C03)
 
A. Whenever the net frequency is quiet, announce your call sign and location.
B. Move 5 kHz away from the net's frequency and use high power to ask other hams to keep clear of the net frequency.
C. Do not transmit on the net frequency until asked to do so by the net control station.
D. Wait until the net frequency is quiet, then ask for any emergency traffic for your area .
 
 
Q 33:  What is a beam antenna?
 (T9A01)
 
A. An antenna built from metal I-beams.
B. An antenna that transmits and receives equally well in all directions.
C. An antenna that concentrates signals in one direction .
D. An antenna that reverses the phase of received signals.
 
 
Q 34:  What is the most likely cause of sudden bursts of tones or fragments of different conversations that interfere with VHF or UHF signals?
 (T9B03)
 
A. The batteries in your transceiver are failing .
B. Strong signals are overloading the receiver and causing undesired signals to be heard.
C. The receiver is picking up low orbit satellites.
D. A nearby broadcast station is having transmitter problems .
 
 
Q 35:  What might be indicated by erratic changes in SWR readings?
 (T9C03)
 
A. The transmitter is being modulated .
B. A loose connection in your antenna or feedline.
C. The transmitter is being over modulated .
D. Interference from other stations is distorting your signal .
 
 

When you have completed your paper and checked your answers press the 'Submit Paper' button to have your paper graded.